English
30
Empty the water
in emergency
If the washing machine can not work normally or the
power outages when the washing machine is working
and there is the rest of the water in the tube washing
machine, then to empty the remaining water follow the
procedures below:
-
Turn off the water faucet and turn the Cycle button
to OFF position.
-
Wait until the water in the washing machine to cool
down. Put a water container.
-
Open the filter cover.
-
Turn the dryer hose cover.
-
Pull the dryer hose water.
-
Remove the water drying hose then put the hose to
the container and let the water flow naturally..
Cleaning
the
Pump Filter
-
Clean the pump filter regularly. Make sure the
washing machine is empty and there is no water in
the tube. Ensure that electrical current has been
interrupted
-
To clean it, place the container or cloth under a
cover or filters to accommodate the remaining
water disposal.
-
Remove the filter by turning it counter-clockwise
and pull out.
-
Rinse the filter by putting it under water spray.
Make sure that the particles contained in the filter
have been lifted.
-
Replace the filter into its place by turning it
clockwise until it clicks into position.
To
clean
the
water
entry
filter
Cleaning the
loading door
and the drum
-
Clean the water entry filter on a
regular basis or if the water filling time
is too long.
-
Close the tap water and remove the
water inlet hose by turning it counter
clockwise.
-
Clean the filter on the back of the
washing machine with a soft brush
and rinse with water.
-
Plug back the water inlet hose as
previously.
-
Residues of softener, detergent and
dirt may accumulate in your machine
in time and may cause unpleasant
odours and washing complaints.
-
To avoid this, use the
Drum Cleaning
programme. If your machine is not
