10
Upper chamber: Temperature can be set from 5
℃
to 10
℃
.
Lower chamber: Temperature can be set from 10
℃
to 18
℃
.
WC 1022 S , WC 1022 L
-
The temperature range can be adjusted from 5 ° C to the highest 18 ° C.
-
When pressing the "Set Upper" or "Set lower", the system will enter the setup mode automatically.
It will increase or decrease the temperature of 1
℃
. When the temperature setting reaches the
highest limit 18 ° C and the lower limit of 5 ° C, the temperature setting will not be able to rise or
drop again.
-
To see the actual temperature, hold or for about 3 seconds. After 5 seconds, it will show
the set temperature.
WC 1022 S, WC 1022 L, WC 2045 S, WC 2045 L, WC 2154 S
Temperature Memory Function.
In the event of a power interruption, wine cooler can memorize and save the previous temperature
setting. When the power is recovered, the cooler temperature will go back to the last set temperature.
WC 1022 S, WC 1022 L
Alarm on In Door Appliance.
When forget to close the door of the appliance or the door is not closed, the alarm will sound
after 5 minutes. Make sure the door is closed perfectly to prevent loss of cold energy in the appliance.
WC 1022 S, WC 1022 L, WC 2045 S, WC 2045 L, WC 2154 S
Temperature Alarm
If the temperature inside is higher than 23 ° C, it will show "HI" on the display panel, and after one
hour the alarm / buzzer will beep. This indicates that the temperature inside is too high. If the
temperature inside is lower than 0 ° C, it will show "LO" on the display panel and at the same time the
alarm also the malfunction indicator is active.
Internal Light
In order to reduce energy consumption, the LED light within this Wine Cooler cabinet will
automatically switch off when the door is closed. You can also set the LED light to remain on
continuously. Press
and hold the “LIGHT” button for 5 seconds, the display will show “LP”. After 4
seconds, the display will be back to normal and the light will stay on until it manually switches off. If
you would like to revert back and save energy (recommended), press and
hold the “LIGHT” button for
5 seconds, the display w
ill show “LF”. After 4 seconds, the display will be back to normal and the light
will
automatically
switch
off
when
the
door
is
closed.
(
FOR WC 1022 S, WC 1022 L,
the light will turn on when door
is
open
ed
and will turn off when door
is
closed.)
Summary of Contents for Scuderia Series
Page 23: ...11 20 ...