7
Installation on the bottom part of the kitchen set
1.
Put the exhaust hood on the bottom part of the kitchen set in
accordance with the planned position.
2.
Mark the bottom parts of the kitchen set for flexible pipe hole and
then create a hole if the exhaust hood is to be operated with ducting
/ exhaust system.
3.
Install the exhaust hood with 4 screws on the prepared position.
4.
To reinforce the exhaust hood handle on the kitchen set, install the
screws on other holes on the upper part and tighten them.
5.
Connect the exhaust system with the spigot / flange if the exhaust
hood is to be operated as a ducting / exhaust system.
OPERATING PROCEDURE
MODENA Exhaust Hood has 2 (two) work methods as follows:
DUCTING / EXHAUST System
:
•
In this mode, the exhaust hood operates by sucking the smoke /
cooking odor and then discharging it out of the vent.
•
A heat / fire-resistant ducting system is required to discharge
smoke / odor out of the vent.
•
To connect the exhaust hood with the discharge duct, use
"spigot/flange" is designed with a diameter of 100 or 125 mm.
Several things which require attention in installing the ducting system exhaust hood:
1.
Carbon filter must be removed because the cooking odor will be
sucked and immediately discharged out of the room.
2.
The suction force will be diminished if the exhaust system is too
long and there are too many elbows.
3.
Do not connect the exhaust system with a chimney or an air duct or
hot steam duct.
4.
If the exhaust hood is to be installed in a multi-storied building or
an apartment, consult with the person in charge of the building /
apartment prior to installing the exhaust system.
5.
Exhaust hood with ducting system should be used in an open-air
room with good air circulation
RECIRCULATING system:
In this version, the exhaust hood sucks the smoke / cooking odor and
filters it through an aluminum filter and carbon filter. The filtered smoke
is then re- circulated into the room. This system is used if the premise
renders it impossible to install a ducting system.
Several things which must be ensured when installing a exhaust hood
with re-circulating system:
1.
Both carbon filter and aluminum filter must be used.
2.
The position of both filters must be correct.
Holes where air duct is discharged found in the front cabinet of the
exhaust hood cannot be closed
