Modellbau Lindinger GmbH
e-Mail: offi[email protected] www.lindinger.at
17
step 3
Locate the motor and fix it with the four screws included in the motor hardware pack, then fix the
controller in the area shown in the picture.
Section 11 – cowl installation
step 1
Apply a piece of masking tape on the line were you have to make the holes for the cowl fixing
screws, then mark the position as per the picture.
step 2
Slide the cowling onto the fuselage and install the spinner back plate. Position and hold the cowl so
there is 10mm gap between the back plate and the cowl from the side view. Then apply another
piece of masking tape on the same line of the one applied before.
