Page
Global Hobby Distributors will not disclose the information it collects to outside parties. We do not sell, trade, or rent your personal information to others . Your privacy is important to us.
iMPOrTANT iNfOrMATiON ABOuT YOur EMAiL ADDrEss
In the USA
Global Services
18480 Bandilier Circle
Fountain Valley, CA 92708
Phone: (714) 963-0329 Fax: (714) 964-6236
Email: [email protected]
Check out our support website at http://globalservices.globalhobby.com
. There you will find public message boards frequented by other Model Tech
product owners and the Model Tech technical support staff. This is a great place to get quick answers and advice on your new product.
To enable us to better serve your needs, please include your email address with any correspondence you send to us. Your email address will be added
to our Customer Service Database so you will automatically receive free updates and tech notices for your particular product. You will also receive
repair status updates (if applicable) and other important information about your product as it becomes available.
In the UK
YT International
15 Parkstone Close
Shelfield, Walsall, West Midlands WS4 1QW
Phone/Fax: 01922-684425
Email: [email protected]
This section describes our recommendations to help you in deciding which types of accessories to purchase for your new airplane.
Please read through this entire section very carefully. We have provided you with recommendations that,
if followed, will result in a great flying airplane. Failure to follow our recommendations may result in a poor
flying airplane.
●
Multiplex BL480/4G Brushless Motor
●
KMS Sentry 40 Amp Brushless ESC
●
APC 10 x 7E Composite Propeller
●
Impulse Power 3C 2100mAH LiPO Battery
●
Pro-Peak Quattro LiPO DC Charger
●
Maxx Products 1/8" Propeller Adapter
You will need to use a 4 or more channel transmitter with a 4 or more channel
standard range mini receiver. Ideally, the transmitter should feature dual rates and
servo reversing. More experienced pilots might also want exponential and mixing
capabilities.
Do not use short-range micro receivers.
The servos you use should be the lightest available, yet still have an adequate
amount of torque. We suggest using mini servos that weigh no more than 18 grams
and have a torque rating of no less than 25 ounces per square inch. The Cirrus CS402BB 18gr mini servos will work well. These
servos are lightweight, small and strong, and produce more than enough torque and speed.
All prototype testing on the Apex 3D EP ARF was done using the Multiplex BL480/4G 480 Brushless Motor with Gearbox. We used
the 4.4:1 gearbox, APC 10 x 7E propeller, KMS Sentry 40 amp brushless ESC, and Impulse Power 3C 2100mAH LiPO battery. The
Apex 3D EP ARF, however, is set up so that both in-line gearbox and Outrunner direct drive motors can easily be used. These motors
include the Hacker A30 series, AXI 2814 and 2217, and KMS 2814 Outrunner motor
QTY. 1 Hitec Optic 6 FM Radio System
QTY. 1 Multiplex BL480/4G Brushless Motor
QTY. 1 KMS Sentry 40 Amp Brushless ESC
QTY. 1 APC 10 x 7E Composite Propeller
QTY. 1 Hitec Electron 6 FM Receiver
QTY. 1 Hitec Crystal for FM Dual Conversion Receivers
QTY. 4 Cirrus CS402BB 18gr Mini Servos
QTY. 1 Impulse Power 3C 2100mAH LiPO Battery
QTY. 1 Maxx Products 1/8" Propeller Adapter
QTY. 2 Cirrus 12" Servo Extension Leads
QTY. 1 Pro-Peak Quattro LiPO Charger
QTY. 1 X'TRA 4mm Gold Connector Set
QTY. 1 Double-Sided Foam Tape
QTY. 1 #64 Rubber Bands
Our rECOMMENDATiONs
rECOMMENDED BrusHLEss POWEr sYsTEM
REcoMMEnDED RADio, REcEivER AnD SERvoS
HErE's A LisT Of WHAT WE usED TO fiNisH THE APEx 3D EP Arf sHOWN iN THEsE iNsTruCTiONs
cUSToMER SERvicE inFoRMATion
