Instruction notice (EN)
13
NOT-JA73-EN-2021-v01
b.
Fixing the actuator on to the torque management device and/or on an adaptor
To ensure the operator is working safely and in optimum conditions, it is imperative to use a torque retention system.
Our actuators are delivered with:
A BR001 torque management reaction bar
A strap or a chain
2 carabiners
In addition to this basic pack,
modec
also has a wide range of torque management accessories (see the catalogue and the
following presentation for more details).
As well as these standard accessories,
modec
develops specific systems. If you would like to check your installation or if you
have a specific solution request, contact a registered
modec
distributor.
The
modec
standard flange and shaft can also accommodate some specific drive heads like the Banjo heads (for handwheels
with a rising stem, or simply in order to increase the torque) or a right angle head (for a better operator position during
operation). These heads also have a torque reaction system (torque retention arm, strap and carabiners).
If this standard equipment does not provide a
torque retention that offers sufficient safety for
both operators and equipment,
modec
can
develop and/or adapt special torque management
systems.
Never use a portable actuator with a torque management system that is under-sized, unstable or badly
positioned
c.
Fixing the BR001 torque management arm and anchoring strap
Pull each fixation spring with the ring and rotate for a quarter turn so that they stay in the pulled position.
Place the black ring of the torque management bar on the flange so that the 6 pins enter the corresponding holes.
Make a quarter turn with the fixation springs rings and release the springs making sure they come back.
Check that the torque management bar is properly secured to the flange.
Fixation
spring
6 pins
Actuator flange
Splined shaft
Ø25x36 mm
Fixation
spring
