8
Mount the L-bracket on the outer surface of the base
using the two long 16 mm screws, nuts and flat washers
as shown in the drawing. The screws should be
inserted from the inside of the base so that the screw
heads are on the inside of the pedal.
Push the tension adjustment screw through the hole in
the L-bracket. Place the pillow block between the two
bearing pin mounts.
Bearing Pin Mount
L-bracket
The non-threaded hole in the pillow block is slightly off center. The
side of the pillow block that the non-threaded hole is closest to should
face up so that it lines up better with the two bearing pin mount holes.
0.15"
0.22"
This Side Up
Screw the tension adjustment screw part way into the
threaded hole in the pillow block.
Slide the bearing pin through the two mounts and the
pillow block as shown in the drawing. Turn the
tension adjustment screw with your fingers until its
head is flush with the back of the L-bracket.
Do NOT
tighten this screw, yet.
Slide the bearing pin out and
set it aside. The pillow block is now aligned for final
assembly.
BASE
OUTER
SURFACE
Mount
Mount
Pillow
Block
Tension
Adjustment Screw
SECTION 2 - Mounting Large Components to the Base
Please refer to DRAWING 1
Using #4 screws, nuts and lock washers, mount the four terminal strips as shown in Drawing 1.
Mount the input jack in the hole on the left side of the base (where indicated in the drawing).
Make sure the two solder lugs are in the most upright position before tightening the nut.
Mount the output jack in the hole on the right side of the base (where indicated in the drawing).
Make sure the two solder lugs are in the most upright position before tightening the nut.
Mount the DC power jack in the 15/32" hole just below the output jack. Orient the lugs on the
DC power jack so the larger center-pin lug is facing the output jack. Tighten the DC power jack.
CENTER-PIN LUG
POSITIVE-SWITCH LUG
POSITIVE LUG
DC Power Jack