TIP LUG
TIP
LUG
GROUND
LUG
1
2
3
4
5
7
8
9
10
11
12
14
15
16
103K
400V
1.5K
103
K
4
00V
470K
47
0K
1K
10K
22
K
270
.22
µ
E
B
C
MP
S
A1
8
Q2
MP
S
A1
8
E
B
C
Q1
1"
13
Installing the Foam Battery Cushion
Locate the remaining piece of double sided foam tape and the gray foam battery cushion. This
will be installed to keep the battery in place.
Remove the backing from one side of the foam tape and attach to the inside of the wah base at
the heel end roughly centered about 1" away from the rear edge as shown by the rectangle in
the drawing below.
Remove the remaining backing of the foam tape and place the foam block over the tape so the
angled corners just clear the screw holes. Press down on the middle of the foam block to make
sure it is firmly secured to the base.
Install a fresh 9 volt battery and lay it over the gray foam block. Place the bottom cover over the
base and attach the base using the feet and their mounting screws.
Fixing a Squeaky Wah
If you find that your wah pedal is squeaking when you rock the
treadle, try squirting WD40 into the four junctions where the
bearing pin meets the bearing pin mounts.
Adjustment of the Footswitch Height
If you find that the
footswitch engages too easily
while rocking the treadle back and forth with
your foot, you can lower the height of the footswitch by swapping the location of the large nylon
washer and the lock washer.
If you find that the
footswitch does not engage
when pressing the toe-end of the treadle all the
way down with your foot for bypass mode, you can raise the height of the footswitch by removing
the lock washer from the switch altogether.
Wah Base
Nylon Washer
Hex Nut
Outside
Inside
Wah Base
Lock Washer
Nylon Washer
Hex Nut
Outside
Inside
Wah Base
Lock Washer
Nylon Washer
Hex Nut
Outside
Inside
Lower
Raise
BASE
OUTER
SURFACE
Mount
Mount
Four Junctions