8
SECTION 2
Please refer to DRAWING 3.
Strip and tin a ¾” piece of wire and connect the lug 3 on the footswitch
to lug 9 on the footswitch.
Solder both connections now.
Strip and tin a 2
” piece of wire and connect lug 8 of the footswitch to
the output jack’s tip lug.
Solder both connections now.
Strip and tin a 2
” piece of wire and connect lug 2 of the footswitch to
the input jack’s tip lug.
Solder both connections now.
Strip and tin a 6
½” piece of wire and connect lug 7 of the footswitch to
the wire joining 2 and 5 of the toggle switch.
Solder the connection at
lug 7 of the footswitch as well as the connection at the toggle switch
now.
Strip ¾” of insulation off of the end of a piece of wire. First tin then snip the
exposed wire from the rest of the wire. Use this piece to connect the center-pin
of the DC power jack to #1.
Solder the center pin connection now.
1
2
3
CENTER
PIN LUG
POSITIVE
SWITCH LUG
POSITIVE
LUG
1
2
3
4
6
7
8
9
4
6
Strip ½” of insulation off of the end of a piece of wire. First tin then snip the exposed wire from the rest of
the wire. Use this piece to join lug 5 with lug 2 of the toggle switch.
Solder both connections now.
Strip and tin a 1
¾” piece of wire and connect #21 to #24 using the bottom
holes for both connections.
Solder the connection at #21 now.
Strip and tin a 1
½” piece of wire and connect #3 to #15 using the bottom
holes for both connections.
Solder both connections now.
Strip and tin a 5
” piece of wire and connect #2 to lug 2 of the 100KL pot using
the bottom hole for the connection at #2.
Solder both connections now.
Connect an 8.2k resistor from #14 to #13 using the bottom holes
for both connections.
Solder the connection at #14 now.
Connect a 100k resistor from #13 to #11 using the bottom holes for both connections.
Connect the 390 ohm resistor from #4 to #13 using the bottom
holes for both connections.
Solder the connection at #4 now.
SECTION 3
Please refer to DRAWING 4.
Strip and tin a 2
” piece of wire and connect the C
r
of the footswitch to
the sleeve lug of the input jack.
Solder both connections now.
Strip and tin a 1
¼” piece of wire and connect lug 4 of the
footswitch to #4.
Solder both connections now.
Strip and tin a 1
½” piece of wire and connect #13 to #20 using the
bottom holes for both connections.
Solder the connection at #20 now.
1
2
3
4
5
6
7
8
14
13
12
11
10
9
15
16
18
19
20
21
22
23
24
17
bottom holes
SLEEVE LUG
TIP LUG
Output Jack
RING LUG
SLEEVE LUG
TIP LUG
Input Jack
1
2
3
4
5
6
C
b
A C
r