Step 7 – Mount the Output Transformer (TR2)
Drawing 3
shows where to mount the output transformer P-T31.
A) Hold the transformer up above the chassis and push the wires through their respective grommet holes as
indicated on the drawing.
B) Place the transformer on the chassis so that the mounting holes line up with the transformer feet.
C) Use #6 mounting hardware to fasten the power transformer in place.
(2)
(2)
(2)
SECTION 2 – Mounting of Front Components
Please refer to D
rawing 4
.
Step 1 – Mount the Lamp Holder
Drawing 4
shows where to mount the lamp holder. Be sure to mount it so that its solder lugs point towards
the bottom opening of the chassis box. (Once the lamp holder is mounted you may screw in the bulb and then
the jewel).
Step 2 – Mount the Power Switch
Drawing 4
shows where to mount the power switch. Be
sure to mount the power switch with its solder lugs
directed toward the chassis top.
Step 3 – Mount the Bass, Treble, and Volume Pots
Drawing 4
shows where to mount the bass, treble, and volume pots. When they are mounted, turn their shafts all
the way counter-clockwise. (Once you have done this, you can mount the knobs while pointing to “0” and
tightening their set screws).
Step 4 – Mount the Input Jack
Drawing 4
shows where to mount the input jack.
(1)
ccw
0
10
It is good idea to use a
contact cleaner on each pot
before mounting.
10
Bend back mounting tabs
250KA
Chassis Bottom
(2)
1MA
Chassis Bottom
(1)
(3)
Set screw