Mod.Cam MOD.01, User Manual, Page: 7 / 29

General product handling
Unpacking and general considerations
Included with your MOD.01 device should be a three metres, charging-only, Micro-b to
Type-A USB cable, a 1A USB Type-A power adapter for your region and a standard two-part
MOD.01 ceiling mount intended for top-down coverage . 1
Boot, shutdown and LED patterns
The MOD.01 device will automatically boot whenever it receives power through its micro-b
USB contact. This means that as a safe-guard against power outages, if power is inserted, it
will automatically boot even when manual shutdown has been performed.
Upon boot, the device will go through a series of patterns with the four LEDs situated
around the camera lens of the unit.
Shutdown
To turn off the device, remove any power source and press the button for at least 6
seconds. During this time, the LEDs will show a countdown pattern (after a couple of
seconds). The countdown ends with a four LED white flash, indicating that the shutdown is
complete.
Standard LED behaviour
1. Blue​ lower right/left light - Pre-boot phase.
2. Blue ​ lights, spinning - Booting.
3. Four ​ orange​ lights, flashing - Not connected to network, scanning for QR code.
4. Four ​ green​ lights, flashing - QR code scanned.
5. Orange ​ lights, spinning - Connecting to network.
6. Orange ​ lights, alternately flashing left/right - Network connection failed.
7. Yellow​ lights, pulsating - Connected, installation not finished, video stream possible.
8. White lights, slowly pulsating - Connected, installed and ready.
Note: ​ Spinning red lights indicate an ongoing over-the-air (OTA) upgrade. Never shut down
the device during this process!
Configuration
1
The actual contents of your package may vary depending of OEM-packaging and point of resale.
>Revision
R3 - 2015-09-14