Mocon CheckPoint 3, User Manual

Page: 44 / 82

DANSENSOR
42 User Guide EN CheckPoint 3
P/N 340486-B
09/2017
Cleaning and Maintenance
General
Performing cleaning and maintenance regularly reduces the chances of equipment failure.
CAUTION! Personnel performing any maintenance or cleaning must familiarize
themselves with the information in
"Safety and handling instructions" on page 75
before attempting any of these procedures.
Cleaning

Disconnect cable (if connected) and turn device off by pressing and holding the button
for approx. 3 s.

Clean all surfaces using a soft, lint-free cloth with a mild soap solution. Avoid getting
moisture in openings.
Replacing filter, needle and measuring gas hose
During use of the device, dust will over time be sucked through the measuring gas system,
and therefore the filter

will have to be replaced regularly.
The needle

may sometimes touch the product being measured or the needle may suck
fluid from the packaging from which the measurement is taken.
If this happens, it will be necessary to replace both the filter

, the needle

, and the hose

.
If there is any dirt or fluid in the measuring gas hose

, it should be replaced or cleaned using
dry compressed air.
CAUTION! When using compressed air for cleaning, the hose must be disconnected
from the device.