MOBILUS Cosmo|L, Manual

Page: 2 / 8

01. PROGRAMMING MODE
WARNING! Do not program the remote control when the shutter is in the extreme position (top
or bottom). Each program and changes of motor’s operation directions are confirmed by two
micro-movements of the driver.
Failure to comply with these rules may result in damage the blinds (inhaled by the housing).
1. Enter MOBILUS motor, serie R in the PROGRAMMING MODE OF MASTER REMOTE:
- press for 5 seconds PROGRAMMING BUTTON in the motor
- Fig . 1a
;
- or double turn off and turn on the power supply od the motor
- Fig. 1b
;
The confirmation of properly performed operation will be two micro-movements of the motor driver -
Fig. 1c
.
Fig. 1
ON OFF ON OFF
2x
a b c
5 s.
WARNING! If no programming action is taken within 20 seconds, the drive will do two
half turns, and the motor will automatically change to the operating mode – it won’t be
programmed.
02. LOADING THE REMOTE CONTROL INTO THE TUBULAR MOTOR MEMORY
1. Remove the control from its frame as some programming buttons are located on the
back side of the control.
- Fig. 2a.
Fig. 2
a b d c
2. Select the right channel ( unless it is a 1-channel control COSMO | L1 ).
- Fig. 2b.
3. Enter MOBILUS motor, serie R in the PROGRAMMING MODE.
4. Press the STOP and UP buttons (on the back side of the remote control) and hold them
until the drive does two half turns.
2