a
- upper LEDs blink in blue - blind / gate is located in the top position.
b
- lower LEDs blink in blue - blind / gate is located in the lower position.
c
- LEDs blink diagonally in blue - the blind is located in the area between the upper and lower limit
switch.
d
- top and lower LEDs blink red light - the additional sound signal - error occurred - blind
encountered an obstacle.
It is possible to query the receiver about its current status. Please select the channel and press
STOP
. The remote will send a question to the receiver. Upon receipt of the response it displays its
status.
11. CHANGE OF MOTOR’S OPERATION DIRECTION
After loading the remote control to the motor check that the buttons
UP
and
DOWN
correspond
to lifting and lowering the blinds
- Fig. 11a.
If not, press simultaneously buttons
STOP
and
DOWN
and hold them for about 5 seconds on the remote control any loaded to the motor. The
confirmation of correctly performed operation are two micro-movements of the driver
- Fig. 11b.
The motor changes the direction of the work on the correct
- Fig. 11c.
Fig. 11
a
b
c
WARNING !
You can change the direction of the work of motor for
MOBILUS
drives with electronic
limit switches only before setting the upper and lower limit switches. You can change the direction
of work for the
MOBILUS
motors with mechanical limit switches at any time.
9
Summary of Contents for COSMO G3+
Page 1: ...User manual of COSMO G3 controller www mobilus pl...
Page 11: ...13 NOTES 11...
