- - 19 - -
adverse environments.
Do not use, water, oil or other chemical solutions to clean your scooter. Be sure NOT to spray the
scooter with a hose or tap as this may cause damage to electronic componentry and the scooter
controller.
Please take the scooter to authorised dealers for repairs and adjustments. Improper adjustments could
lead to an accident or scooter malfunction.
Please use a soft, wrung dry cloth to keep your scooter tidy and dust-free. Use natural or mild detergent
to clean the scooter.
Attention
When conducting maintenance of your vehicle, turn the power switch to OFF and remove the
charger cords
Suggestions
Do not splash water directly to wash your scooter as this could lead to malfunction of the system
electrics.
Do not use petrol, solvents or vaporizing solution as these may deform or damage the shrouds. Do
not use wax.
7.5 STORAGE
Ensure the scooter is stored under the following conditions:
Ensure the seat is set in the ‘forward’ position
Ensure the scooter is switched off
Ensure the charger is disconnected when not in use
Suggestion
Please store the scooter in an environment where it is out of direct sunlight or damp. When
storing for a long time, charge the battery to full power and then disconnect the battery terminal.
For more details contact to your dealer.
7.6 MOVING ABOUT
Switch off the power with the ignition key before moving. Always dismount from the scooter before
moving.
Lift the scooter by the chassis, and not by the bumpers. Lifting the scooters by the bumper could cause
damage or injury.
For your safety, always ask for help if required. You will need two people when moving or lifting
the scooter whole. If you are on your own, please disassemble the scooter before lifting. Refer to
the section below.
7.7 DISASSEMBLING THE SCOOTER
Both the models of scooter can be disassembled in to four pieces. These are the seat (weight 6kg), the
front section (Prism 3-wheel front section weight 14.6kg, Prism 4-wheel front section weight 19.1kg),
the rear section (weight 10.6kg), and battery pack (weight 9.8kg) without any tools
The procedure for disassembly is the same for both scooters. Please follow the steps and photographs
below:
