Mobilex A/S
Grønlandsvej 5
DK-8660 Skanderborg
www.mobilex.dk
–
1 backrest
–
1 red, plastic safety handle
–
2 red plastic wingnuts for handle assembly
–
1 soap holder
–
1 user's manual
Assembly & folding description
Check with the list from above if nothing is missing. If you’d discover at that stage that some
part is missing or damaged, do not continue assembly process. Contact your supplier of the
product right away.
Take main frame and open legs by pulling them to the side until you'll hear a “click” sound of
legs safety lock buttons. Repeat the same for the other side of the bench.
WARNING! Always before usage ensure that legs are fully opened and locked in that position
(as shown on picture above)
Put the backrest in to it's place by pressing it in to 2 dedicated rectangular holes located at
the back of the seat pad. Check if the backrest went all the way and is locked in it's place
safely.
Place safety handle's ends in to 2 holes on the side of the seat pad (as shown on picture
above). Use 2 red wing nuts to tie down the handle to the seat by applying them from the
bottom.
INFORMATION! You can assemble handle on either right or left side of the seat. Your choice
depends on conditions of your bathroom and your personal preferences. For safety reasons it
is the best to attach handle on that side of seat which is located at the most outside when
bench is sled out of the bathtub.
Place soap holder at one of the sides of the seat pad by pressing holder's tail in to dedicated
hole. You can choose the side of bench where you prefer to have holder attached.
Adjusting the legs. Legs should be assembled in the way, where 2 wideer rubber feet will be
located inside of the bathtub and 2 narrower feet will be standing on the bathroom's foor.
Legs are preassembled in factory, but if you want to stand your bath bench in oposite
direction that it comes from factory preset, you can easily take away the bottom part of legs
and switch their sides.
Legs are equipped with push button locks. Simply press on the button located on each leg,
and pull the bottom part of the leg. In this way you can switch the legs' sides or adjust their
length.
Check the diference between foor level and bathtub's bottom level which usually is located
higher. Adjust the legs in the way, where bathtub's feet are higher than foor feet. The
diference in their length should be the same as the diference between foor and bathtub's
bottom level. Then bath bench placed correctly should be leveled. The leg length should also
be adjusted so the seat is free to slide and hangs over the bathtub sidewall. The seat's frame
should not touch bathtub's top.
Rev. 12/17
Page 3 of 5
UM-302065-GB
Safety
Handle
Safety Handle
wing nuts
leg
Pivot Point
with
Lock
detachable
Backrest
Sliding Seat
sliding function
Release Lever
leg height adjustment point
with
Push Button Lock
Bathtub Foot
Floor Foot
Soap Holder
a better life in motion
