Signal strenght indicator
Downlink input
power range
(Solid light)
Off
< -71 dBm
Bad, might be problems or will not work at all.
≥ -70 dBm < -66 dBm
Will probaly work but limited range indoor. Instal-
lation can be sensitive to outdoor conditions like
rain/snow.
≥ -65 dBm < -61 dBm
Works, but not at optimal performace.
≥ -60 dBm < -56 dBm
OK
≥ -55 dBm < -51 dBm
Very good.
≥ -50 dBm
Works at optimal performace and maximum
internal coverage.
Manual gain mode
When not using Smart Mode, you can manually lower your repeaters gain by adding attenation. Every
press och the - or + button will manually decrease (or increase) the total gain by 1 dB. You can manually
decrease gain from 70 down to 36 dB.
While pr or - the LED bars will be blinking to show you your settings. After 1-3 seconds the LED
bar will automatically stop blinking and start showing Signal strength again. The new signal strenght is
showing including the new gain/attunation.
This can be very useful if you have very strong input signal or if you need to keep internal repeater
signals from leaking out from your house/appartment/office or if your operator is experiencing interfer-
ence from your repeater.
LED Bar (BLINKING)
Gain
Attunation
70-64 dB
0-6 dB
63-57 dB
7-12 dB
56-50 dB
13-18 dB
49-43 dB
24-29 dB
42-36 dB
25-30 dB
