Remote - Web Browser Session
MA 850A1A1 Installation and Configuration Guide
33
6.
Click
Finish.
The
Device Installer
Main window reappears and the
installed unit will be listed in the window.
What next?
Define the SNMP parameters according to Configuring the SNMP Parameters, page 33.
4.2.1.4
Configuring the SNMP Parameters
Configure the SNMP Community and Trap destination addresses according to the instructions in
this section.
NOTE:
The required communication parameters are pre-set for each MA 850A1 unit. However if
you do not succeed in connecting to the Telnet application, verify the serial
communication
section
1.
Select the MA 850A1 unit which will be configured (may be identified
according to its MAC address value) and click the
Telnet
button in the
toolbar.
The Telnet dialog shows the IP address of the currently connected MA 850A1 unit.
Figure
4-11. Telnet IP Address window
2.
Click
OK
and immediately press
Enter
to go into Setup Mode. The current
settings will be displayed, followed by the
Change Setup
menu.
Change Setup:
0 Server configuration
1 Channel 1 configuration
3 SNMP configuration
7 factory defaults
8 exit without save
9 save and exit Your choice ?
3.
Enter
3
(SNMP Configuration).
