Remote - Web Browser Session
MA 850A1A1 Installation and Configuration Guide
34
4.
Set the SNMP Read and Write community names and the SNMP traps destination addresses
(up to three addresses can be defined) by responding with
Y
to the prompt
Set the
Gateway IP Address
and defining the Address (as illustrated below).
SNMP community name for read ():
public
SNMP community name for write ():
private
Enter IP addresses for SNMP traps:
1: (000) 192.(000) 168.(000) 10.(000) 22
2: (000) .(000) .(000) .(000)
3: (000) .(000) .(000) .(000)
5.
Press
Enter
to run through the rest of the parameters. When the Setup
Menu is displayed again, select
9 – Save and Exit.
4.2.1.5
Configuring Serial Parameters
This section describes how to verify and configure the serial communication parameters for each
MA 850A1 unit.
1.
From the
DeviceInstaller
Main window, select the MA 850A1 unit to be configured and click
the
Configure
button the toolbar. The Configure Device dialog appears.
Figure
4-12. Current Serial Port Parameters
