Mobile ECO MINEY, Operating Instructions & Parts List Manual

Page: 3 / 13

When attaching the handle, you had better squat just behind the pallet truck. Then you:
2.1 Insert the draw-bar onto the pump piston (303) , then use a hammer to insert the axle with
hole (G105) into the hydraulic pump and draw-bar from the right to left. (See fig. 2 ).
2.2
Let control handle(G117) to the ‘
LOWER
’ position, then pass the adjusting nut(G104),
adjusting bolt(G103) and chain(G102) through the hole of axle(G105) with your hand (See fig. 3).
Fig. 2
2.3 Press the draw-bar (G110) down, take
away the pin (#2) (See Fig. 1).
2.4 Let the control handle (G117) on
‘
RAISE
’ position, then raise the lever
plate (319) with the pin (#2) and
insert the adjusting bolt(G103) into the
front slot of lever plate (319), note to
keep the adjusting nut (G104) on the
under side of the lever plate.
2.5 Use a hammer to tap another elastic pin (G106) into the axle with hole (G105).
The draw-bar is now assembled to the pump.
3. TO ADJUST RELEASE DEVICE
On the draw-bar of this pallet truck, you can find the control handle (G117) which can be
regulated in three positions:
Raise -handle down
Drive position -handle in center position
Lower -handle up, the lever moves back the drive position when released.
If however they have been changed, you can adjust according to following step:
3.1 If the forks elevate while pumping in the DRIVE position, turn the adjusting nut (G104) on the
adjusting bolt (G103) or screw (318) clockwise until pumping action does not raise the forks
and the DRIVE position functions properly.
3.2 If the forks descend while pumping in the DRIVE position, turn the nut (G104) or screw (318)
counter-clockwise until the forks do not lower.
3.3 If the forks do not descent when the control handle (G117) is in the LOWER position, turn the
nut (G104) or screw (318) clockwise until raising the control handle (G117) lowers the forks.
Then check the DRIVE position according to item 3.1 and 3.2 to be sure the nut (G104) and
screw (318) is in the proper position.
Fig.3