Mobicool MB40 AC/DC, Operating Manual

Page: 10 / 188

EN
Operation MB40 AC/DC
10
➤
To switch off the cooler:
– Disconnect the plug.
– Wind the cable around the two holders on the back of the device for
storage.
I
Connecting the cooler to 230 V (compressor mode)
➤
Connect the 230 V connection cable (fig.
1
3, page 2) to the 230 V AC
mains supply.
➤
Open the lid of the thermostat (fig.
2
3, page 2) by pressing down on it.
I
➤
Turn the thermostat (fig.
2
3, page 2) clockwise to the required position.
I
✓
The cooler starts cooling the interior.
➤
To switch off the cooler:
– Turn the thermostat (fig.
2
3, page 2) anti-clockwise to “0”.
– Disconnect the plug.
– Wind the cable around the two holders on the back of the device for
storage.
7.3 Connecting to vehicle power
I
NOTE
Disconnect the cooler from the battery when the engine is not run-
ning, as otherwise the battery will run down.
NOTE
Press down on the lid again to close it.
NOTE
The further you turn the thermostat towards “MAX”, the lower the
refrigerating temperature.
NOTE
If you connect the cooling device to the vehicle power, remember
that you may have to turn on the ignition to supply it with power.
MB40_OPM_EMEA16.book Seite 10 Dienstag, 1. Oktober 2019 6:09 18