8
4.4.7 Input delay time
The input delay time defines the time that the input are triggered before an alarm is initiated. If the
input returns to the non-alarm status within the delay time, no alarm is sent. The time can be set
between 0 and 999 seconds.
As default, the input delay time is set to 1 second.
SMS command alarm delay input 1:
<CODE>
DELAY1:xxx
SMS command alarm delay input 2:
<CODE>
DELAY2:xxx
4.4.8 Inactive time
Th
e “inactive time” defines the time input 1 or input 2 is not active after an activation.
In
case the time is set to “0” (minutes), the input is active again immediately after returning to the
non-alarm status. In case the time is set to e.g. 30 minutes, the input remains inactive for the first
30 minutes. In case the input is again (or still) activated after these 30 minutes, a new alarm
message is sent.
The time can be set between 0 and 60 minutes. As default, the inactive time is set to
“0”.
SMS command inactive time input 1:
<CODE> INACTIVEIN1:xx
SMS command inactive time input 2:
<CODE> INACTIVEIN2:xx
4.4.9 Alarm repeat time
In order to emphasize the urgency of the alarm messages, all alarms can be repeated. As long as
the alarm status has not returned to the inactive status, the SMS alarm will be repeated after the
‘alarm repeat time’. The time can be set between 0 and 24 hours. As default the alarm repeat
time is set to 4 hour.
SMS command alarm repeat time:
<CODE> REPEAT:xx
4.4.10 Test SMS text message
The Mobeye PowerGuard can send regular test SMS messages
(´keep alive’) to the
administrator, to ensure the proper functioning of the unit. The test message function is only
active in case the unit is armed.
The interval between the test messages can be set between 0 days (no test message) and 30
days. The default test interval is set to 0 (no test message).
SMS command interval test message:
<CODE> TEST:xx
4.5 RESET OF SYSTEM
To reset the Mobeye PowerGuard to its factory settings:
-
Remove the batteries and external power supply
-
Press the outside button while entering the batteries. Keep it pressed for (about) another
5 seconds
-
Release the button immediately after the LED starts to flash
-
Reconnect the external power supply
After a successful reset, the status LED on the keypad will blink green to indicate that the module
is not configured. The security code <CODE> is back to factory settings as well.
