Mobeye MS100EK, Installation Manual

Page: 8 / 24

6
Connect the external power adapter (or any other regulated 9-32VDC
power supply) to the power input of the connector (press on the
orange pins for connecting the wires):
•
V+ (black lead with white stripe) to “+”
•
Ground (black lead) to “-“
If using the Mobeye mains adapter (Mobeye article 10027):
The black wire with the white line
is “+”, the other black wire is “-“.
2.4 CONNECT THE BACK-UP BATTERY
For back-up power, in the situation that the external power was
cut, a rechargeable Mobeye battery can be connected.
Attach the terminal of the battery to the white connector. The
battery can be fixed with tie wraps or Velcro.
If the power falls out, the unit will keep sits functions and a power
failure message can be sent. The GSM module remains open
and the sensor inputs remain active. The back-up battery is able
to power the module for at least 24 hours.
Close the Mobeye MS100EK using the 4 screws.
2.5 PROGRAM THE PHONE NUMBERS
You need to program at least one phone number in the unit as alarm number.
•
Enter your 4 digit code (factory setting: “1111”)
•
Press “menu”
•
Enter “101”
•
Press “OK”
•
Enter the phone number (e.g. 0712345678 or 0044712345678)
•
Press “OK”
The light turns green and a confirmation melody is played. The Mobeye MS100EK is ready to
use.
2.6 CHECK THE SETTINGS
The settings can be sent to the programmed telephone number as SMS text message. In this
way you also check the correct working of the SIM card.
•
Enter your 4 digit code (factory setting: “1111”)
•
Press “menu”
•
Enter “10”
•
Press “OK”
Within ca. 30 seconds the programmed phone number (TEL1) will receive the list with settings.
2.7 SWITCHING ON
The Mobeye MS100EK is switched on automatically after programming the first telephone
number. To switch on/off manually, please refer to 2.8.
+ -