© MOBATIME
24 / 40
800845.01
The daylight saving time has been set to start on last Sunday in March at 2
o’clock and end on last Sunday in October at 3 o’clock in the above
described example.
By pushing
OK
save the setting and return to item
dt:
. Another push of the
OK
button returns to the clock menu item
P6
.
6.6
Setting of the predefined temperature value
It is possible to display a predefined temperature value in each temperature
display field without need for the temperature sensor.
Set the value
0
in the
P13
(or
P14
or
P15
respectively) menu item, and then by
pushing the
SET
enter the submenu for setting the temperature preset.
The display shows
Fxx.x
. The item to be set is blinking.
Enter temperature preset value in format
xx.x
, the range is from
00.0
to
99.9
degrees.
By pushing
OK
, the entered values are stored and the display returns to the
menu item
P13
(or
P14
or
P15
respectively). By pushing
ESC
return without
storing.
6.7
Settings for the TP3 / TP30 temperature sensors
Set the value
1
in the
P13
(or
P14
or
P15
respectively) menu item, and then by
pushing the
SET
enter the submenu for setting the address and measured
temperature correction.
The display shows
A : x
.The item to be set is blinking.
Enter the address of the sensor, use value
1
for
Temp1
input or
2
for
Temp2
input. Push the
>>
button to move to the temperature correction setting.
The display shows
cxx.x
.
Enter temperature correction value in format
xx.x
, the range is from -9.9 to +9.9
degrees.
By pushing
OK
, the entered values are stored and the display returns to the
menu item
P13
(or
P14
or
P15
respectively). By pushing
ESC
return without
storing.
6.8
Settings for the TP RS485 temperature sensors
Set the value
2
in the
P13
(or
P14
or
P15
respectively) menu item, and then by
pushing the
SET
enter the submenu for setting the address, measured
temperature correction and communication mode.
The display shows
A : x
. The item to be set is blinking.
Enter the address of the sensor, see the address printed on the sensor body and
use the table in the chapter 11 for searching of the numerical representation of
the particular address.
Push the
>>
button to move to the temperature correction setting.
The display shows
cxx.x
.