MOBA R.3CHS, User Manual

Page: 10 / 28

10
For model R.ULS.B, if powering up using the ON/OFF button, the Power
On LED will flash to indicate when in low internal battery condition. If the
internal battery is too flat the unit will not power on at all. Recharge the unit
or power externally through the military connector.
To indicate the Centre Band setting selected, the three inner LED clusters
(8, 9 and 10) briefly illuminate in a particular pattern when the Centre Band
button is pressed. Table shows which pattern corresponds to each
setting.
3
For internal battery model R.ULS.B, simply switch the unit on using the
On/Off button ( ) or alternatively connect the military connector to an
external power source using an optionally supplied power cord.
13
2.1.2 Setting The Centre Band Resolution
On power up, the green Power On LED (6) will light to indicate the
Laserguide is powered and the LED clusters will flash in sequence from top
to bottom as part of initialisation. At completion of the sequence, the three
inner LED clusters (8, 9 and 10) will briefly light in a particular pattern to
indicate the current centre band setting. Table in section shows the
centre band setting corresponding to each illumination pattern.
3 2.1.2
Using the optionally supplied remote control or through the Laserguide's
own button interface (R.ULS.B only) the Centre Band setting can be
changed using the Centre Band button ( ). Three settings are available,
from most accurate to least: Fine, and Wide. Each press of the
button steps through these options.
,
12
Medium
© Copyright MOBA Mobile Automation Australia Pty Ltd
Operating the Laserguide