11
>N=?GAPOLNKRE@A@KNOQLLHEA@=OłPPEJCO
Under no circumstances turn the appliance on if it is on any sur-
face.
The appliance must not be recessed in the ceiling. There must be
enough space around the top of the appliance to ensure adequate
=AN=PEKJ2OAKJHUPDA>N=?GAPOOQLLHEA@KNPDAKLPEKJ=HKJAOPKłT
the appliance.
A minimum air gap of 30 cm should always be allowed between
the top of the heater and a ceiling or roof. The appliance should be
?IB=NBNKIPDAS=HHOĠłC=J@
A safety distance of not less than 100 cm should always be left in
BNKJPKBPDAH=?GHECDPDA=PANOKNPKKJA=N
This unit should be mounted at a minimum of 180 cm above ground
HARAHĠłC&BEJOP=HHA@EJ=PKEHAPPDADAECDPODKQH@>A?IEJ
VKJA=J@VKJAĢEJVKJAPDAIEJEIQI=>KRACNKQJ@HARAHEO
180 cm, according with the rules of each Country.
The appliance must not be located neither directly below, nor in
BNKJPKB=OK?GAPKQPHAP
The heater must be installed so as to prevent that the switches can
be touched from those who are in the shower.
"JOQNAPD=PPDANAEOJKLKOOE>EHEPUKBEJŃ=II=>HAI=PANE=H?KI
-
bustible material or curtains coming into contact with the heater,
or lie near the heater.
The product is in class I and IP55, wich is the protection rate for
PDAQJEPOPK>AQOA@ARAJKQP@KKN#KNGAALEJCPDALNKPA?PEKJN=PA
of the appliance, the connection of the appliance with the power
supply must be done by means of a minimum IP55 system, as per
the standards HD 384 CENELEC for Europe, or international IEC
60346-7-708 1988.
3. FITTING
Before being used, the heater must be fixed to the wall or to the
ceiling by means of the provided supports, as described below. Be-
fore drilling the holes for the dowels, be sure that the wall is solid
and that you are far from water tubes or electrical wires. Be sure
that the heater is not facing the ceiling or inflammable materials.
