MLT PLYS 15, User Manual, Page: 6 / 16

The cutting thickness is adjusted by turning the height regulation control found on the right hand side.
Perform a test on a corner of the belt, or on a scrap piece of the same material, to see if the height adjustment and pressure
is correct.
Separate the belt ply belt applying one or more passes, depending on the hardness or substance of the material being
worked on, and depending on the adjustment of the table’s opening guide.
WARNING
WHEN CHANGING THE BLADE, DISCONNECT THE POWER CORD FROM THE MAINS, TO AVOID ACCIDENTS.
Changing and adjusting the blade
Take off the blade support by removing the two M10 Allen screws using an 8 mm Allen key.