MLT PLYS 15, User Manual, Page: 5 / 16

NOTE
Although the initial cut is 100 mm, keep in mind that depending on the toughness of the material used, various passes must
be done in order to obtain the desired final width.
WARNING
THIS DEVICE INVOLVES THE HAZARD OF HANDS BEING TRAPPED AND CUT BY THE PINCH ROLLERS. THE USER
SHOULD EXERCISE GREAT CARE AND PRECAUTION IN THE MATERIAL ENTRY ZONE, AVOIDING THE PLACEMENT OF
HANDS IN THIS ZONE.
Once the equipment is connected to the mains, it must be fixed to a table or support through the four holes in its base, to
avoid overturning or falls.
Always adjust the cutting guide to less than 100 mm, before introducing the material.
User
instructions