Fig. 3
• Secure the mains cable under the cable clamp and refit the terminal cover
• To remove the bezel, turn anti-clockwise
• To refit the bezel, turn clockwise
• Lift both spring clips on the sides of the fitting and push into the ceiling
• Switch on and check for correct operation
•
With the aid of a cross-head screwdriver, remove the cover to access the mains terminal block (see
Fig 2)
Fig. 2
•
Connect the luminaire to the mains supply ensuring that correct polarity is observed: L - Live
(brown), E - Earth (green/yellow), N - Neutral (blue) (see Fig. 3)
Fig. 3
•
Secure the mains cable under the cable clamp and refit the terminal cover
•
To remove the bezel, turn anti-clockwise
•
To refit the bezel, turn clockwise
•
Lift both spring clips on the sides of the fitting and push into the ceiling
•
Switch on and check for correct operation
WARNING
This luminaire must be disconnected from the circuit if subjected to any high voltage or insulation resistance
testing. Irreparable damage will occur if this instruction is not followed
GENERAL
The LED lamps fitted in this product are non-replaceable. The product should be recycled in the correct manner
when it reaches the end of its life. Check local authorities for where facilities exist
Clean with a soft dry cloth only, do not use aggressive cleaning products or solvents which may damage the
product
This product is dimmable with most trailing edge dimmers
WARRANTY
L
L
E
E
N
N
WARNING
This luminaire must be disconnected from the circuit if subjected to any high voltage or insulation resistance
testing. Irreparable damage will occur if this instruction is not followed .
