INSTALLATION
• Provide power to the required point of installation
• Cut a suitable hole in the ceiling as per the cut-out details (see Fig. 1) ensuring not to
infringe with any joists, gas / water pipes or electrical cables
• Attach the connector mounting arm by slotting into either one of the spring clips on the
fitting
• Remove the cable clamp on the terminal block then remove the terminal cover by
unscrewing the red screw on the top to access the terminal block
• Connect the luminaire to the mains supply ensuring that correct polarity is observed (see
Fig. 2): L - Live (brown), E - Earth (green/yellow), N - Neutral (blue)
Fig.1
Fig.2
Part code
Cut-out size
RDSHxxx
64mm
These instructions should be read carefully and retained after installation by the end user for future
reference and maintenance.
These instructions should be used to aid installation of the following products:
RD1, RD2 & RDSH
SAFETY
•
This product must be installed in accordance with the latest edition of the IEE Wiring
Regulations (BS7671) and current Building Regulations. If in any doubt, consult a qualified
electrician
•
Please isolate mains prior to installation or maintenance
•
Check the total load on the circuit (including when this luminaire is fitted) does not exceed
the rating of the circuit cable, fuse or circuit breaker
•
Please note the IP (Ingress Protection) rating of this luminaire when deciding the location for
installation
•
This product is Class I and must be earthed
•
RD1 & RD2 are IP20 rated, RDSH is IP65 rated
INSTALLATION
•
Provide power to the required point of installation
•
Cut a suitable hole in the ceiling as per the cut-out details below ensuring that it does not
infringe with electrical cables, water/gas pipes or ceiling joists
Part code
Cut-out size
RD1
70mm
RD2
80mm
RDSH
64mm
•
Attach the connector mounting arm by slotting into either one of the spring clips on the
fitting
•
Unscrew the cable clamp on the terminal block then remove the terminal cover by
unscrewing the red screw on the top to access the terminal block
•
Connect the pre-wired terminal block to the mains supply ensuring correct polarity is
observed
•
Brown – LIVE, Blue – NEUTRAL, Green/Yellow – EARTH (see Fig. 1)
Fig. 1
