Receiver
• Press the two holding clips on the battery cover on the rear of the receiver and pull open
• Insert 3 x AAA batteries (not included)
• Replace cover
Mounting bell push
• When using screws and wall plugs provided to attach to a surface, open the bell push
and pierce the two fixing holes on the baseplate of the bell push
• Mark the location of the fixing holes and drill ensuring not to infringe with any gas/water
pipes or electrical cables
• Screw the baseplate to the wall and re-attach the cover
• To attach using the double-sided adhesive pad, ensure the surface is clean and dry
• Peel back one side of the pad and attach to the rear of the bell push then peel back the
rear of the pad and attach to the desired surface
Mounting PIR sensor
• Using the bracket as a template, mark the location of the fixing holes and drill ensuring
not to infringe with any gas/water pipes or electrical cables
• Screw the bracket to the wall using the screws and wall plugs provided
• Attach the ball bracket to the rear of the sensor, then attach to the bracket mounted to
the surface
• Adjust the bracket to change the detection distance and angle of the sensor
• It is recommended to mount the detector 2.0~2.2m from the ground to cover maxima
detection area
