• Ensure a minimum of 300mm of drainage below the luminaire (see Fig. 2).
• When installing into decking, ensure there is enough clearance below so the fitting, cable, and driver are not
in standing water
• There must be enough cable below the luminaire in order to carry out maintenance work (see Fig. 3)
•
Ensure a minimum of 300mm of drainage below the luminaire (see Fig. 2).
•
When installing into decking, ensure there is enough clearance below, so the fitting, cable, and driver
are not in standing water
•
There must be enough cable below the luminaire in order to carry out maintenance work (see Fig. 3)
Fig. 3
•
Connect the + (brown) and
–
(blue) into the secondary terminals of the 24v constant voltage driver
(see Fig. 4)
•
The minimum and maximum load of the driver must be observed
•
Connect the constant voltage driver to the Live (brown) and Neutral (blue) of the mains supply
•
We recommend that a maximum cable run of 10m of 0.75mm² CSA cable be used in the parallel circuit
•
Switch on and check for correct operation
Fig. 4
WARNING
This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance
testing. Irreparable damage will occur if this instruction is not followed.
This product is not suitable for installation in or near a coastal or marine environment.
GENERAL
The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole
luminaire should be replaced.
Clean with a soft dry cloth only, do not use aggressive cleaning products or solvents which may damage the
product.
• Connect the + (brown) and – (blue) into the secondary terminals of the 24v constant voltage driver
(see Fig. 4)
• The minimum and maximum load of the driver must be observed
• Connect the constant voltage driver to the Live (brown) and Neutral (blue) of the mains supply
• We recommend that a maximum cable run of 10m of 0.75mm² CSA cable be used in the parallel circuit
• Switch on and check for correct operation
Fig. 3
