MK-100
Revision 1/01, Effective Date January 23, 2001
Page 24
SETUP, ADJUSTMENT and OPERATION
7. Cleanup:
NOTE: If an external water source was used, steps A through C may be skipped
Ensure the saw is disconnected before completing the remainder of the cleanup process.
(D)
Ensure the ON/OFF Switch
is in the OFF position
Off
Position
ON/OFF
Switch
(F)
Unplug MK-100 from the GFCI
(E)
Unplug the GFCI from the
Power source
(B)
Place the Water Pump
In an external container
(A)
Clean the Water Pump
suction of all debris
(C)
Run the MK-100 until clear
water is seen at the blade
cooling ports (Approx. 1 minute)
(H)
Remove the Water Basin
from the MK-100
(I)
Clean the Water Basin
(G)
Clean the MK-100 with
soap and clean water
Clean Water
Basin
Soap and
Fresh Water
Pump
Suction
Water Pump
In container
External
Container
Cooling Flow
Points
Unplug
GFCI
Slide Water Basin
out front of Saw
