MK-100
Revision 1/01, Effective Date January 23, 2001
Page 11
UNPACKING, TRANSPORT, UNIVERSAL STAND and ASSEMBLY
UNPACKING:
Your MK-100 has been shipped from the factory thoroughly inspected. Only minimal assembly is required.
Use proper lifting techniques when lifting the MK-100.
If not done, remove the MK-100, Cutting Head and accessory box from the carton.
CONTENTS:
In your container, you will find one (1) MK-100 frame and water basin, one (1) MK-100 Cutting, one (1) 10-
inch wet cutting continuous rim diamond blade, one (1) adjustable cutting guide, one (1) electric water pump,
one (1) pump discharge fitting, one (1) cooling transfer tube, one (1) flow adjusting clamp, one (1) drain plug,
one (1) blade wrench one (1) splash guard, one (1) owners manual, one (1) pump manual and one (1)
warranty card.
MK-100 Frame
and Water Basin
MK-100
Cutting Head
Diamond Blade
Adjustable
Cutting Guide
Electric
Water Pump
Pump
Discharge Fitting
Cooling
Transfer Tube
Flow
Adjusting Clamp
Drain Plug
Wrench
Splash
Guard
Owners
Manual
Pump
Manual
Warranty
Card
TRANSPORT:
1. The MK-100 weighs approximately ninety-seven (97) pounds; use care when transporting.
2. Never transport the MK-100 with water in the Water Basin.
The MK-100 is designed with a rigid frame and removable Cutting Head. Two people are required to
transport the MK-100 with the Cutting Head installed. The Cutting Head must be removed first, if one person
is transporting the saw (see Cutting Head Installation and Removal in the following section).
To lift the saw using two people, each person will grasp the front and back portion of the frame. To lift the
saw using one person, remove the Cutting Head first, and then grasp the front and back of the frame.
Transport the Cutting Head and the Frame seperately.
Cutting Head
Lift Point
Lift Point
