(Note: In order to gain an extra 10dB of headroom on the low frequency effects (LFE) channel, Dolby
specifies that this channel be recorded 10dB lower than the 5 main channels. This 10dB lower level is made up in
the playback chain to restore the correct 5 channel to .1 channel balance. For additional information please see
the "Dolby Digital Professional Encoder Manual" which is available from the Dolby website. (www.dolby.com)
8.
CONNECTING FOR DTS
1.
Connect the left, center, right, left surround and right surround outputs of your mixer to the left, center, right,
left surround and right surround input channels of the LFE-4.
2.
Connect the outputs of LFE-4 to the inputs of your power amplifiers or directly to your powered
loudspeakers.
3.
Connect the mixer output assigned to the low frequency effects channel (LFE) to the +0 dB input of
the LFE-4.
4.
Connect one of the subwoofer outputs of the LFE-4 to the XLR input of your subwoofer. Set your M&K
Professional subwoofer as follows: set the filter switch to THX, set the phase switch to plus and set the gain
switch to the THX position.
Bass Management Controller
10
RIGHT SUR
IN
RIGHT SUR
OUT
LEFT SUR
IN
LEFT SUR
OUT
RIGHT
IN
RIGHT
OUT
CENTER
IN
CENTER
OUT
LEFT
IN
LEFT
OUT
LFE IN
+0 dB
LFE IN
+10 dB
SUB OUT
1
SUB OUT
2
24 VAC
IN
CHASSIS
GND
SIGNAL
GND
Surround monitors
3-channel power amplifier
M&K powered subwoofer
Main monitors
2-channel power amplifier
FIGURE 6:
DTS 5.1 CONNECTIONS
