20
MK-4000 SERIES
OPERATION
NOTICE
Read the engine instructions manual before starting.
1. Check engine oil. Add oil if low.
2. Check fuel level. Add fuel if low.
3. Check cooling air intake areas and external surfaces of engine. Make sure surfaces are clean and
unobstructed.
4. Check that air cleaner components and all shrouds, equipment covers and guards are in place and securely
fastened.
WARNING
Be sure blade is unobstructed and not resting on ground.
WARNING
Be sure hands and feet are clear of blade.
STARTING ENGINE
STARTING INSTRUCTIONS
1. Place FNR Handle in
NEUTRAL.
2. Verify Neutral Engagement Handle is down, in
NEUTRAL.
3. Pull Engine Throttle Handle out half-way (Kubota only).
4. Start engine by rotating Ignition Switch to the right.
5. When engine is warm, throttle may be used out to maximum position.
6. To stop engine, push throttle to idle, rotate ignition switch to “OFF” position.
NOTICE
DO NOT crank engine for more than 30 seconds at a time. If engine fails to start, wait about 2 minutes
between cranking periods to prevent starter from overheating.
NOTICE
Allow engine to warm up at least 3 minutes before applying load.
NOTICE
If the engine has been running hard and is hot, do not shut engine off abruptly. Cool engine by removing load
and allowing engine to run idle for 3 to 5 minutes.
Summary of Contents for MK-4018HY
Page 4: ... MK 4000 SERIES Notes ...
Page 29: ...29 MK 4000 SERIES NOTES ...
