15
MK-24 SERIES ASSEMBLY
FILLING OIL RESERVOIR
PROPANE SAWS
(A)
Verify the Oil Drain Cap is installed
onto the Oil Drain Line and is tight.
Refer to Engine Manual for details.
(A)
Place propane bottle on tank mount
with bolt through tank slot.
(B)
Close clamp on tank mount.
(C)
Attach hose.
(C)
Install one Washer onto each bolt.
Install bolt through the Handlebar
and into the holes and tighten.
Follow the assembly instructions to prepare your saw for operation.
(A)
Locate the threaded holes on
both sides of the handlebar.
(B)
Align the handlebar with the
holes on both sides of the frame at
the desired height.
HANDLEBAR ASSEMBLY
The engine is shipped with no oil in the crankcase. Refer to the engine manual for de-
tails on the type and amount of oil required.
To fill the crankcase with oil, place the engine level. In order for this to be accomplished
the blade must not be installed, and the depth adjustment must be down (until the en-
gine is level).
The engine and oil must be warm and your saw must
be on level ground to get an accurate oil level reading.
NOTE:
NOTE:
