15
MK-2000 ELECTRIC SAW
PRODUCT SPECIFICATIONS
GENERAL DESCRIPTION
PRODUCT SPECIFICATIONS
MOTOR SPECIFICATIONS
Model
MK-2001SV
MK-2001SV
MK-2002
MK-2002-16
MK-2002-16-CC
MK-2002E
Motor
ABB (Baldor)
Hill House
ABB (Baldor)
ABB (Baldor)
ABB (Baldor)
ABB (Baldor)
Motor Part #
161099
168022GH
231095
172729
172729
231095
Horse Power
1.5 hp
1.5 hp
2.0 hp
2.0 hp
2.0 hp
2.0
Amps
14.4
12.23
8.8
8.8
8.8
16.8/8.4
Voltage/Gas
120V
115V
120V/230V
230V
230V
230V
Overall Amperage
14.4 a
12.23 a
16.8 a/8.4 a
11.5 a
11.5 a
16.8 a / 8.4 a
Motor RPM
1725
3400
3450
3450
3450
3450
Blade RPM
2540
3000
3100
2800
2800
3100
Weight
220 lbs.
220 lbs.
220 lbs.
180 lbs.
195 lbs.
275 lbs.
Part #
161195
161195
150598
150598-16
150598-16-CC
158751
Operated and used according to this manual, the MK-2000 Electric Saws will provide years of
dependable service.
The MK-2000 Electric Saws are engineered as portable brick saws powered by either a 1-1/2 or 2
horsepower electric motor. The saw is capable of cutting masonry up to five (5) inches (127 mm) with
a 14" blade or six (6) inches with a 16" blade in height, sixteen (16) inches in length in a single pass.
Motor specifications for the MK-2000 Electric Saw are listed below.
NOTE: The MK-2000 series is also available with a 50hz motor.
THERMAL OVERLOAD PROTECTION
BLADE CAPACITY
MASONRY TYPES
SPRING ASSISTED CUTTING HEAD
The motor is protected by a thermal overload equipped with a manual reset.
The MK-2000 Electric Saw is designed for use with a 14-inch or 16-inch diameter segmented wet or
dry MK Diamond blade with a .110 to .375 inch cutting width.
The MK-2000 Electric Saw can cut a variety of masonry types including, cinder block, slump stone
block, wall brick, paver brick, concrete block and cylinders, roofing tile, marble, granite, decorative
rock or almost any other non-ferrous material.
NOTE: The MK-2000 Electric Saw is not designed to cut plastic or metals.
The MK-2000 Electric Saw is designed with a spring-assisted cutting head to allow for easier step
cutting. The Cutting Head can be locked in the down position when cutting smaller pieces.
