SAFETY WARNING
1. Warning
﹡
Every person involved with the installation , operation and maintenance of this device has
to be qualified .
﹡
User must follow the instructions of this manual
﹡
Unqualified person can not open the housing cover and operate the device , or the dealer
will not accept liability for any resulting defects or problems.
﹡
The device against rain and moisture
2. Waring notes :
﹡
Power supply : AC 100V-240V , 50/60Hz
﹡
Make sure the power switch is off , the power plug , outlet and the earth connection is in
well condition before connecting the device with the mains.
﹡
Please use qualified power plug and the outlet. Never connect the power cord of this
device with other electrical equipment.
﹡
During move and installation , make sure the device not crashed with metal parts and other
tough materials.
﹡
Always disconnect from the mains, when the device is on the installation and dismantled
﹡
The minimum distance between light-output and the illuminated surface must be more than
50cm
﹡
The device must only be installed on a non-flammable surface . In order to safeguard
sufficient ventilation , leave 50cm of free space around the device . Please note that
heat-sensitive objects may be deformed or damaged by the emitted heat .
﹡
During the operation the housing becomes very hot ! Do not operate the device for 15
minutes after switching off .
﹡
The maximum ambient temperature Ta = 45
℃
must never be exceeded , The maximum
housing temperature Tb = 80
℃
must never be exceeded .
﹡
For indoor use
﹡
Replace any visible cracked protective shield , filters and lens .
﹡
The protective shiel, filters and lens will require weekly cleaning as smoke “Cfluid tends
to building up residues , reducing the light “Coutput very quickly.
6
Speed of the Fan
The fan will start to work when the working temperature reach 40 degree, and the
speed will be changed according to the change of temperature.
Can support reverse display
1.2 Multi-light working in the same time
When using controller to control multi lights to work in strobe or auto run, the controller just
send the channel data . The strobe and auto run effect will be depend on each light itself . And
please take attention for the follow situation:
1.
There will be many situations make the lights are not synchronization in the beginning.
(For example: the different time of opening the light , or different time of them connect to the
controller) .In this case, you can change value of the controller( for example push 20 to 0, and
back to 20), then it can be synchronization.
2.
Due to crystal frequency of different lights are not the same exactly, so it may not be
synchronization after long time.
3.
If need to keep synchronization for long time, there are two ways to do so:
A. Using the controller to edit program make the strobe, auto run effect, then they must
be synchronization.
B. Using the Maser/Slave model
2. Channel data
2.1 Standard channel model
Channel
Data
Function
CH1
0~255
Red
CH2
0~255
Green
CH3
0~255
Blue
CH4
0~255
White
3
