1
1. Safety Instruc ons
WARNING
Please keep this User Guide for future consulta on. If you sell the unit to another user, be sure that
they also receive this instruc on manual.
Important:
Damages caused by the disregard of this user manual are not subject to warranty. The dealer
will not accept liability for any resul ng defects or problems
.
Unpack and check carefully that there is no transporta on damage before using the unit.
The unit is for indoor use only. Use only in a dry loca on.
DO install and operate by qualified operator.
DO NOT allow children to operate the fixture.
Use safety chain when fixing
the unit. Handle the unit by carrying its base instead of head only.
The unit must be installed in a loca on with adequate ven la on, at least 50cm from adjacent
surfaces.
Be sure that no ven la on slots are blocked, otherwise the unit will be overheated.
Before opera ng, ensure that the voltage and frequency of power supply match the power
requirements of the unit.
It’s important to
ground the yellow/green conductor to earth in order to avoid electric shock.
Maximum ambient temperature TA: 40
℃
. DO NOT
operate it when
the temperature is higher.
DO NOT connect the device to any dimmer pack.
During ini al start-up some smoke or smell may arise. This is a normal process and does not
necessarily mean that the device is defec ve, and it will decrease gradually within 15 minutes.
Make sure there are no flammable materials close to the unit while opera ng
to avoid fire hazard.
Examine the power wires carefully; replace them immediately if there is any damage.
Unit’s surface temperature may reach up to 85
℃
. DO NOT touch the housing bare-handed during
its opera on, and allow about 15 minutes for cooling the unit down before replacing bulb or
maintenance as it could be very hot.
Avoid any inflammable liquids, water or metal objects entering the unit. Once it happens, cut off
Please read the instruc on carefully which includes important informa on about
the installa on, usage and maintenance.
the mains power immediately.
24
8 . Cleaning
The cleaning of internal and external op cal lenses and/or mirrors must be carried out periodically
to op mize light output. Cleaning frequency depends on the environment in which the fixture
operates: damp, smoky or par cularly dirty surrounding can cause greater accumula on of dirt on the
unit’s op cs.
Clean with so cloth and use normal glass to clean liquid.
Always dry the parts carefully.
Clean the external op cs at least every 20 days. Clean the internal op cs at least every 30/60 days.
☆
Important no ce:
•
In this instruc on for use contains about the installment and the use aspect
important informa on of the LED BSW moving head. When installing and using, you
need to look this usage instruc on strictly.
• Before open the LED moving head and if you want to do the repair work, please
make sure the power source is at the separa on condi on.
• Every unit is tested completely and packed properly by the manufacturer. Please
make sure the packing and the unit are in good condi on before installa on and use.
Should there be any damage caused by transporta on, consult your dealer and do not
use the unit. Any damage caused by improper use will not be assumed by the
manufacturer or dealer.
A en on:
Unceasingly carries on the product improvement about our company the
policy, in this instruc on booklet carries the data will have the possibility to be able to
change in the future, when no longer separate no ce change ma ers concerned. Our
company retains when the product improvement changes the related specifica on
the authority. This instruc on booklet publisher cannot be responsible regarding this
instruc on booklet in informa on accuracy, also cannot the related consequence
which causes regarding these informa on be responsible.
