Using six holes in slate slatron as a guide drill pilot holes
/
,
in Cross Beams using a 1 8 drill bit Secure center section
/ "
.
#
#
# .
:
19 to Cross Beams 13 with six screws 7
NOTE Be
sure there are no gaps between center section
#
7
and slats
If gaps exist tighten screws more
.
,
.
However do not tighten screws so much that center
secton begins to crush or crack
.
THE FOLLOWING STEP REQUIRES
THE HELP OF ANOTHER ADULT
!
Detail A
Figure 10
1
0.
20
.
21
.
CAUTION
:
Be sure countersunk holes in all three table
top sections 18 and 19 face up See Detail A
Figure
#
#
:
" ",
18
.
19
.
Place center section 19 in the center of table and ensure
that it is centered on the long slats 43 that you installed
per the Assembly Addendum
#
#
.
NOTE before proceeding if you have not already done
so you must first complete the steps outlined on the
included Assembly Addendum
:
.
,
.
Place end sections 18 onto the table Be sure they are
#
.
square in line and butted up tight against center section 19
,
#
.
22 Using four holes in slate slatron as a guide drill pilot holes
.
/
,
in Cross Beams and Center B am using a 1 8 drill bit
e
/ "
.
Secure end sections 18 using screws 7 four scrws per
#
# (
end section
) .
:
NOTE Be sure there are no gaps
between end sections
18 and
Run your
.
#
table
finger across the two seams between center section
#
#
19 and end sections
18 to check for any uneven
areas Sections should be even
.
.
You should not need shims to even up the table top sections
#
#
,
,
18 and
19
so if the sections do not aligh first try
loosening screws and brush out undreneath to remove
chips etc
Then check under table to make sure there are
..
no gaps between the table top sections and the slats If
.
gaps exist tighten screws more However do no tighten
,
.
,
screws so much that the sections begin to crush or crack
.
Top edges of seams must be precisely level and even with
one another If you need to use shims read the shimming
.
,
instrustions on the following page
.
Page
7
