21 |
P a g e
3/28/2017
8. Tighten the screws and fit the end-caps to cover up the screws in order to resist any tampering with
the camera angles
9. If the optional external Cameras (3 and 4) are installed, click on Camera 3 and Camera 4 to verify
that they are facing the correct view and that the alignment is correct.
4.1.2
Verifying the microphone installation
1. Connect an Ethernet cable from the MVR1204 unit to the laptop
2. Open the MiX Vision utility
3. Click on Refresh
4. A unit serial number "MVR1204 xxxxx" should appear in the device list
5. Select the device
6. Click on Camera 2 and ensure that the audio quality is clear.
4.1.3
Status LEDs on the MVR1204 unit
LED
LED Status
Operating Status
Camera 1- 4
Solid Green
Camera plugged in and active
100ms on / 1s off
Camera not plugged in or inactive
Power
Solid Red
Ignition is on and MVR has booted and has received at
least 1 watchdog ping from the FM unit.
Flashes Red every 10 s Ignition is off and MVR is in shutdown mode
Flashes Red every 4s
Ignition is on and unit has booted – but has no
communication with the FM unit or are still booting up
SD Card
Flashes Green
Unit is writing to the SD card
SYNC
Permanently Off
Power Down Mode / Charge only Mode
500ms on / 500ms off
Limited network service: No SIM card inserted or no PIN
entered, or network search in progress or ongoing user
authentication or network login in progress
10ms on / 3990ms off
Idle Mode: The mobile is registered to the GSM
network(monitoring control channels and user
interactions) No call is in progress and no data transfer
10ms on / 1990ms off
Packet switched data transfer is in progress
UMTS data transfer is in progress
Permanently on
Connected to remote party or exchange of parameters
while setting up or disconnecting a call