20 |
P a g e
3/28/2017
3
440FT0621
to
440FT0814
Unplug the waterproof
connector (about 5 cm
behind camera) and plug
the two ends of the
extension cable into the
two connectors (one leads
to the camera and one
leads to the MVR1204)
4
440FT0621
Install the Camera.
Use the straight bracket if
you can access the panel
from behind, otherwise use
the L-bracket.
Use the MiX Vision Installation Utility to ensure the camera is orientated correctly (dot facing to the top of the
picture). Loosen the screws on the side of the camera to adjust the ball until the camera is 100% horizontally
aligned and facing the correct view. Tighten the screws in order to lock the camera into position.
4.
Verifying the installation
4.1.1
Verifying the camera installation
1. Connect an Ethernet cable from the MVR1204 unit to the laptop
2. Open the MiX Vision utility
3. Click on Refresh
4. A unit serial number "MVR1204 xxxxx" should appear in the device list
5. Select the device
6. Click on Camera 1 to verify that camera 1 is facing the road and that alignment is correct
7. Click on Camera 2 to verify that camera 2 is facing into cab and that alignment is correct