FIG. 16
TC0169e
MITSUBISHI TRITON 3 PIECE TONNEAU COVER
29/10/10
Page 6 of 13
PLACE RETAINER CLIPS (WITH TAG FACING
LEFT
) OVER FRONT OF BOTTOM HINGES. SECURE THE BOTTOM HINGES AND THE
RETAINER CLIPS TO THE HEADER RAIL USING POP RIVETS AS SHOWN.
APPLY SILICON TO THE UNDERSIDE OF THE BOTTOM HINGES AS SHOWN AND POSITION THEM ON THE HEADER RAIL.
REMOVE THE MASKING TAPE FROM THE HEADER RAIL AND APPLY RUST INHIBITOR TO DRILLED HOLES.
ISSUE05
FIG. 19
FIG. 18
FIG. 17
2
11
APPLY RUST
INHIBITOR
REMOVE
MASKING
TAPE
1
2
23
11
11
1
11
12
10
NOT SUPPLIED
CLEAN HEADER RAIL AND HINGES (WHERE EXTRUSION WILL SIT) WITH ALCOHOL WIPES PROVIDED AND WIPE AWAY RESIDUE
WITH A DRY CLEAN CLOTH. PLACE THE EXTRUSION TAPE SEAL ALONG THE TOP OF THE HEADER RAIL WITH THE SEALING
LIP FACING TOWARDS THE TAILGATE. START THE EXTRUSION AT THE EDGE OF THE SIDE RAIL.
IMPORTANT: POSITION
EXTRUSION AS CLOSE TO THE HEADER RAIL REAR RADIUS. RUB DOWN FIRMLY TO ENSURE MAXIMUM ADHESION.
18
24
11
18
12
REAR
NOTE: SEALING LIP
MUST FACE TAILGATE
REAR OF VEHICLE
START EXTRUSION
AT EDGE OF SIDE RAIL
POSITION EXTRUSION
AS CLOSE TO REAR RADIUS
18
12
11
HEADER
RAIL
