– 10 –
•
When heating operation starts, the cold air outlet is blocked, so the flap and louver move to the horizontal / center position, and resume the position that was set
after the warm air output begins.
•
When the compressor stops because the room temperature is higher than the temperature setting and it is in DEFROSTING operation, the flap and louvers will be
in the horizontal / center position.
•
The air flow direction cannot be set in the instances above. Change the air flow direction settings after the warm air starts flowing and it moves to the airflow
direction that had been set.
NOTE
Air flow direction adjustment procedure
Adjusting air flow direction
■
Up/down direction can be adjusted with the AIRFLOW
(UP/DOWN) button on the remote control. Each time when you press this button
the mode changes as follows:
Change to AIRFLOW (UP/DOWN) mode.
(Swing)
(Flap stopped)
■
Left/right direction can be adjusted with the AIRFLOW
(LEFT/RIGHT) button on the remote control. Each time when you press this
button the mode changes as follows:
Change to AIRFLOW (LEFT/RIGHT) mode.
(Louver stopped)
(Swing)
MEMORY FLAP (FLAP OR LOUVER STOPPED)
When you press the AIRFLOW (UP/DOWN or LEFT/RIGHT) button once while the flap or louver is
operating, it stops swinging at an angle.Since this angle is memorized in the microcomputer, the flap or
louver will automatically be set at this angle when the next operation is started.
HEAT
(Horizontal
blowing)
(Slant forward
blowing)
COOL, DRY
•
Recommended angle of the flap when stopping
DANGER
•
Avoid constant airflow to the body for hours on end.
CAUTION
•
When in COOL or DRY operation, do not operate for hours on end with the air
flow blowing straight down. Otherwise, condensation may appear on the outlet
grill and drip down.
•
Do not try to adjust the flaps and louvers by hand, as the control angle may
change or the flap or louver may not close properly.
RKT012A755_En.p65
1/11/06, 5:38 PM
10
Black
