74
5 INSTALLATION
5.5 Connecting Methods for CPU Module and Extension Devices
Connecting method E - connection of extended extension cable
and connector conversion adapter
This subsection explains the procedures for connecting an extended extension cable and FX5-CNV-BC to the extension cable
of the FX5 extension module.
Connecting method F - connection of a bus conversion module
and an FX3 intelligent function module
This subsection explains how to connect the FX3 extension module to the bus conversion module.
1.
Separate the case of FX5-CNV-BC into two pairs as shown
right figure. To separate the case, use a precision flathead
screwdriver. Slightly insert the tip of the screwdriver into part
A shown in the right figure, and the hook (B in the right
figure) will come off (4 places).
2.
Connect the extended extension cable on the upstream side
(C in the right figure).
3.
Connect the extension cable on the downstream side (D in
the right figure).
4.
Pull the tab (E in the right figure) outside, fit the upper cover
(F in the right figure) and the lower cover (G in the right
figure), and press down the upper cover until it is hooked.
1.
Connect the extension cable (A in the right figure) from the FX3
extension module to the subsequent extension connector of the
bus conversion module.
This illustration is FX5-CNV-BUSC. When FX5-CNV-BUS is used,
connect the extension cable to the bus conversion module in the
same way.
B
A
A
A
A
1
1
4
4
3
2
C
E
F
D
E
G
A
Summary of Contents for MELSEC iQ-F FX5UC
Page 1: ...MELSEC iQ F FX5UC User s Manual Hardware ...
Page 2: ......
Page 15: ...13 CONTENTS ...
Page 183: ......
