1.3
Unit Accessories
Each of the Graphic Data Access Units comes with the following accessories.
The battery F
2
-40BL is inside the unit and
can be replaced by following the instructions
later in this manual (Page 5-4).
Mounting brackets and screws (6 of each) are
included with each unit for fitting into a panel.
A seal is also supplied and when all mounting
brackets are properly fitted IP 65 is possible.
1.4
Optional Accessories
For communication with an FX or A system the
FX-40DU-CAB cable is required.
F o r p r o g r a m m i n g a n d s e t - u p t h e
FX-PCS-DU/AT-C software can be used. Please
s e e t h e a p p r o p r i a t e m a n u a l s f o r m o r e
information.
Figure 1.1
F
2
-40BL
Figure: 1.2
Mounting Brackets (6)
Figure: 1.3
Seal
Figure: 1.4
FX-40DU-CAB
Figure: 1.5
FX-PCS-DU/AT-C
Graphic FX-50DU-TK(S)-C Units
Introduction 1
1 – 4
