3.4
Data Access Unit Mounting
Cut a hole in the panel (1) to the appropriate dimensions as shown below. If required fit
the seal (2) before inserting the unit into the panel. Insert the unit (3) squarely into the
panel.
The FX-50DU-TK(S)-C must be fitted with the 6 brackets provided (4); 2 each on the top
and bottom and 1 on each side. The hooks of the brackets should be fitted into the holes
on the unit (5) with the lugs facing towards the back (6) of the unit. The screws can then
be inserted into the brackets (7) and tightened up to the panel. Tighten to a torque of 3 to
5 kg.cm (2.6 to 4.3 inlb).
(4) fit all 6
brackets
Figure: 3.3
Securing with brackets
66 (2.60)
120
(4.72)
5 (0.20) or less
about 110 (4.33)
FX-40DU-CAB
seal
Figure 3.4
Allowed clearances
(5) fit
hook
into
hole
(6) lugs
backwards
(7) insert
screw
121
−
0
+
1
(
4.76
−
0.00
+
0.04
)
161
−
0
+
1
(
6.34
−
0.00
+
0.04
)
mm
(inches)
Figure: 3.5
Cut-out Dimensions
(2) fit seal
(1) cut hole
(3) insert unit
Graphic FX-50DU-TK(S)-C Units
Installation Notes 3
3 – 4
