Mitsubishi HS-U776, Owner'S Manual

Page: 9 / 68

7
IMPORTANT IMPORTANT
You cannot connect both a satellite receiver and a
digital cable box.
You may need to purchase an audio cable and an S-
video cable for this hookup.
If possible, you should have connected your VCR to
your TV with an S-Video cable. It will allow you to
watch the satellite video signal on your TV even
when the VCR is off if you set the Rear S-through in
the S-VHS Set-Up menu to ON.
If you connect your VCR to your TV with a standard
video cable, you will have to turn the VCR on to
watch the video signal from the satellite receiver.
You will be able to hear the audio signal from your
satellite receiver both when the VCR is on and off.
When you connect a satellite receiver to the S-
video input on the back of the VCR, you have to set
the Rear S-input in the S-VHS Set-Up menu to ON.
Refer to your Satellite Receiver Owner’s Guide for
Satellite dish to Satellite receiver connections, as
well as other possible video connections to your
TV.
Connections to Satellite Receiver
S-VIDEO
VIDEO L R AUDIO
OUT OUT
VIDEO AUDIO R L/MONO S-VIDEO
IN 1
R
L
R L
White Yellow
Yellow
Red
White Red
VCR Rear Panel
Satellite Receiver Rear Panel
Connect it only if the satellite
receiver does not have S-Video Output.
If you have an RCA DSS
®
, Sony DSS
®
, Toshiba DSS
®
,
Panasonic DSS
®
, Hughes DSS
®
, PRIMESTAR
®
, or DISH
Network
™
satellite system, you can connect the satellite
receiver to your VCR and then set up the VCR to change
the channels of the satellite receiver. This will allow you
to program your VCR to make unattended recordings
from several different satellite channels.
1 Connect the red and white audio cable to AUDIO
OUT R and AUDIO OUT L on the satellite receiver.
Connect the other end to the AUDIO IN R and
AUDIO IN L on the back of the VCR. Match the
colors of the connectors to the cables.
2 Connect the S-video cable to S-VIDEO OUTPUT on
the satellite receiver. Connect the other end to the
S-VIDEO IN on the back of the VCR.
If your satellite receiver does not have S-VIDEO
OUTPUT, connect the video cable to VIDEO
OUTPUT on the satellite receiver. Connect the
other end to the VIDEO IN on the back of the VCR.
3 See page 9 for IR Emitter connection.
connecting both a satellite receiver and a cable
box with audio video outputs
1 Connect the satellite receiver to the audio video
inputs on the back of the VCR as shown.
2 Connect the cable box to the audio video inputs on
the front of the VCR.
Hooking Up Your VCR
DSS
®
is a registered trademark of DirecTV, Inc.
PRIMESTAR ® is a registered servicemark of PRIMESTAR Partners LP.
DISH Network
™
is a registered trademark of EchoStar Communications Corp.