31
•••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• Operations
ENGLISH
Cautionary items concerning motion detection
• If changes are detected repeatedly, alarm recording is also started repeatedly. Thus functions such as setting
change, etc., will not be accepted. In this case, press the ALARM HOLD button to forcibly stop the motion detection
function for a period of 5 minutes. During, this time, settings can be changed. This manual stop is automatically
restored after 5 minutes and the history of the manual stop is left in the history of the WARNING LOG LIST. To
cancel the alarm hold, press the ALARM HOLD button again.
• For the input signals of alarm recording, ALARM IN terminal on the rear is constantly given priority over the others.
If the motion detection setting is active, alarm recording is started when the ALARM IN terminal is grounded or
when motion is detected.
• The motion detection indicator lights when the motion detection function is in operation and flashes when motion
is detected or during alarm hold.
• The motion detection of this unit may not operate correctly depending on the conditions of the inputted video
signals. Take caution when connecting to a system, etc., that uses the motion detection function to set off alarms,
etc.
• To perform alarm recording during motion detection, set “A-PPS” of the corresponding camera number in the
<RECORD SETTING> to other than “- - - - -”.
• Motion detection will not operate while making settings in the <MOTION DETECTION SETTINGS>.
1
<MOTION DETECTION SETTINGS>
SELECTION CAMERA NUMBER
MOTION DETECTION OFF
DETECTION MASK SETTING
SENSITIVITY HIGH••<<<LOW
>>MOTION THRESHOLD 1
TEST MODE
Setting ( default : “1” )
“ 1 ” , “ 2 ”, • • • • • “191”, “192”
！
For MOTION THRESHOLD, set the number of
active dots in the detection area as the upper limit.
The motion detection function will not operate when
setting a value that exceeds this number.
1. Select the camera to set the motion threshold in
“SELECTION CAMERA NUMBER” (
see page 29).
2. Display the desired setting in “MOTION THRESHOLD” and
turn the SHUTTLE ring clockwise.
• The setting is confirmed.
■
TEST MODE
The set motion detection operation is tested here.
• • • • • • • • • • • • • • • •
• • • • • • • • • • • • • • • •
• • • • • • • • • • • • • • • •
• • • • • • • • • • • • • • • •
• • • • • • • • • • • • • • • •
• • • • • • • • • • • • • • • •
• • • • • • • • • • • • • • • •
• • • • • • • • • • • • • • • •
• • • • • • • • • • • • • • • •
• • • • • • • • • • • • • • • •
• • • • • • • • • • • • • • • •
• • • • • • • • • • • • • • • •
1. In “SELECTION CAMERA NUMBER” (
see page 29),
select the camera to test operates.
2. Set “MOTION DETECTION” on the next row to “ON” and
turn the SHUTTLE ring clockwise.
• The setting is confirmed.
3. Select “TEST MODE” and turn the shuttle ring clockwise.
• The operation test begins.
4. To end “TEST MODE”, turn the SHUTTLE ring counter-
clockwise.
• During test operation, active areas of motion detection are
displayed using “ • ”. The screen displays “
&
&
&
&
&
” when motion
that meets the each condition of sensitivity and number of
dots for recording start is detected. If the motion detection
does not operate properly, set the conditions again.
